Office and Business Park Roofing in San Antonio and Austin

Office and Business Park Roofing in San Antonio and Austin

We replace, recover and retrofit roofs on office buildings and business parks in San Antonio and Austin, from low-slope office roofs crowded with HVAC units to metal-roofed flex buildings along Loop 1604. Access and protection are agreed around the people using the building.

Parapet and wall of a building reclad in sandstone-colored rainscreen panels

Leaks above occupied offices

Water near electrical equipment, IT rooms or ceiling finishes needs attention. We relate the leak location to the roof above, check the covering, drainage and nearby connections, and tell you whether the roof is ready for a recover or replacement.

Working with a property management team

We agree the site contact, affected areas and tenant communication before work begins. The plan covers access to the roof and any temporary changes to entrances, parking or maintenance routes.

Deciding how much roofing to replace

Many office roofs are low-slope. When the existing membrane is worn but the insulation below is dry, a TPO recover goes over it without a tear-off; trapped moisture or a damaged deck means a full TPO replacement. We explain which materials can remain and which need removing.

Office roofing services

TPO roofing

New TPO, TPO replacement and TPO recover for low-slope office roofs, with flashings built around each HVAC curb and roof hatch.

Metal roof retrofit

A new metal roof over the old one on flex and office-warehouse buildings, set on sub-purlins and installed while tenants keep working below.

Protective coatings

Rust and cut-edge treatment and a restoration coating for sound metal roofs on business park buildings, applied with air intakes protected.

R-panel roofs and walls

Replace worn R-panel roofs and walls on metal business park buildings, with insulation and connections included in the plan.

Insulated panels and roof openings

Insulated metal panel walls and roofs where a building refresh needs better insulation, coordinated with skylight and roof work.

Noise, air intakes and occupied areas

We discuss preparation methods and working hours with the site team. Nearby air intakes and the sensitivity of rooms below can affect when work takes place and what separation is needed.

Equipment access during and after the work

HVAC units still need servicing after the roof is refurbished. We consider access routes and the roof connections around equipment, coordinating any equipment alterations with the responsible contractor.

Planning around a lease or fit-out

If a tenant move or interior refurbishment is approaching, reviewing the roof at the same time can help avoid later leaks affecting new finishes. Replacing the roof before new ceilings go in is simpler than working above them afterward.

Talk to us about your office roof

Contact us with the address, current concerns and any planned changes to the building. For office parks around Boerne and the wider San Antonio area, see San Antonio commercial roofing; for buildings around Cedar Park and the wider Austin area, see Austin commercial roofing.

Frequently asked questions

Office And Business-park Roofing FAQs

Can our offices stay occupied while the roof is replaced?

Yes. We work the roof in sections, keep the building covered every night, and agree with the property manager which rooms sit below each day's work. Noisy work above occupied areas can move to early mornings, evenings or weekends.

How do you keep roofing odors out of the building?

We locate every fresh-air intake before work starts, plan adhesive and coating work away from them or for times when the units can be shut down, and cover intakes where the building manager agrees. Heat-welded TPO seams need no adhesive at the seam itself.

Our office roof is flat and worn. Should we recover or replace it?

If the insulation is dry and the deck is sound, a TPO recover over the existing roof avoids tear-off above occupied offices. If cores or a moisture survey show wet insulation, the old roof comes off and we install a full TPO replacement.

What happens to the HVAC units during the roof project?

They usually stay in place. We raise or replace curbs where the new roof needs it, coordinate any disconnection with your mechanical contractor, and leave clear service routes so technicians can reach the units afterward.

How do you keep tenants informed on a business park?

We agree one site contact with the property manager, share the work schedule and affected areas in advance, and give notice of any changes to parking, entrances or deliveries. Tenants hear from their manager, not from crews on the roof.

Can roof work be scheduled outside office hours?

Yes, for the noisiest steps, such as fastening through to the deck or cutting panels. Much of a TPO recover or retrofit is quiet enough to run during the working day once the building manager has agreed the plan.

Our business park buildings have metal roofs. What are the options?

Sound metal with rust at laps and fasteners can take a protective coating. A failing roof with good structure suits a metal retrofit on sub-purlins, installed while tenants stay in. Badly damaged sheets are replaced with new R-panel.

Should the roof be done before a tenant fit-out?

Yes, where you can. New ceilings, lighting and finishes are easier to protect when the roof above is already new, and a fit-out period can give roof crews clearer access to the areas below.

Can insulated metal panels refresh an older office building?

Yes. Insulated metal panel walls give a clean modern face and improve insulation in one step, and they can be installed on new framing in front of tired cladding. We coordinate windows, entrances and roof edges with the new panels.

Do you work on office parks in Boerne and Cedar Park?

Yes. Both are within our two markets: Boerne sits on I-10 northwest of San Antonio, and Cedar Park is northwest of Austin. Tell us the address and how the buildings are used, and we will plan around the tenants.

UK refurbishment experience, a Texas office

Refurbishment specialists

Our business grew through roof and cladding refurbishment in the UK. That experience shapes the work we now offer from our Texas office.

Repair what can be retained

We investigate the roof problem and explain what can be repaired, restored or replaced, so you can decide how to invest in the building.

Roofing and cladding together

We can coordinate roof, insulation, wall panel and drainage work, including the connections where separate repairs can leave problems behind.

A plan for your working building

We agree access, work areas and protection with your site team, including any restrictions needed while the roof is opened.

Roofing and cladding systems

Roofing systems and materials for Texas facilities

Rustoleum Logo
Sika Logo
Kingspan Logo
Morin Logo
American WeatherStar Logo
GAF Logo
TAMKO Logo
PAC-CLAD Logo
1

Tell us about the building

Start with the address and the roof or cladding problem. Photographs are helpful if you already have them.

2

Arrange a site visit

We review the affected areas and discuss how you use the building and what you want the work to achieve.

3

Review the quotation

Your quotation explains the proposed repairs or refurbishment, the areas included and the price.

4

Agree the work plan

We discuss timing, access, deliveries and protection with your site contact before work begins.

5

Complete the work

We carry out the agreed work and discuss any changes needed if opening the roof reveals additional damage.

6

Handover

We review the completed work and provide the care information and documents included in your project.