Revision context
Document record
This six-page technical information sheet, TIS 611, is dated August 25, 2026, and covers UltraPly TPO SA with Secure Bond Technology. The membrane is a heat weldable thermoplastic polyolefin sheet with a factory-applied pressure sensitive adhesive, reinforced with a polyester weft-inserted fabric. The sheet states that it meets or exceeds ASTM D6878-11 and ASTM D6878M-17 and 19. It is self-adhering, and no primers or adhesives are required on horizontal surfaces.
The sheet gives a minimum installation temperature of 20 degrees Fahrenheit (-7 degrees Celsius) and rising. Vertical surfaces before flashing are primed with Single-Ply QuickPrime Primer, Single-Ply LVOC Primer or Elevate Jet Bond Membrane Adhesive. The method of application covers field and roof edge installation. It calls for a relaxing period of at least 30 minutes, release liner removal at a 45-degree angle by two persons, broom application, and rolling with a 5 lb per lineal inch weighted roller, with a note against rolling over ISOGARD HD or Resista or ISOGARD CG.
The item table lists 0.060-inch by 10-foot by 100-foot rolls in tan, gray and white.
Material changes / notes
Official manufacturer technical resource matched to this product by product name. Confirm the current revision at the source before use.