PAC-Tite Fascia Systems

PAC-Tite Fascia Systems are factory-formed roof edge fascia from Petersen under the PAC-CLAD name. All fascia is made in 12 ft lengths. Seven lines make up the range:

• PAC-Tite Angular Fascia
• PAC-Tite WT Canted Fascia
• PAC-Tite WT Fascia
• PAC-Tite WT Extended Fascia
• PAC-LOC Fascia
• PAC Snap Edge Fascia
• PAC Snap Edge Extended Fascia

PAC-Tite Angular Fascia is made for single-ply and built-up/modified roof systems in two versions: fully adhered/mechanically attached single-ply (FA) and built-up/modified (BUM). It is made in 24 gauge steel and .040 aluminum, including mill finish and clear or colored anodized .040 aluminum. It is tested to ANSI/SPRI ES-1 and FM Approvals, has Miami-Dade Notices of Acceptance, and a lifetime 215 mph wind warranty applies.

An extruded aluminum anchor bar terminates the membrane and can dry-in the roof structure. The design is non-penetrating, so no stripping in or heat welding is needed. Pre-punched slotted holes allow thermal movement.

Worksheets cover BUM and FA scuppers, FA and non-90 degree miters, radius work, fascia extenders and SB radius.

PAC-Tite WT Fascia is made for smaller face heights on heavier covers. It is made in 22 gauge steel and .050 and .063 aluminum, including mill finish and clear or colored anodized. It is also made in FA and BUM versions and tested to ANSI/SPRI ES-1 for International Building Code compliance. Interlocking concealed splice plates prevent splice plate migration. A lifetime 215 mph wind warranty applies.

The anchor bar is extruded aluminum and terminates the membrane. The design is non-penetrating, so no stripping in or heat welding is needed, and pre-punched slotted holes allow thermal movement. Mill finish and clear or colored anodized finishes are offered in .050 and .063 aluminum. A parapet detail is published for the FA version.

Factory-fabricated accessories include miters (FA and non-90 degree), scuppers (BUM, FA and Sure-Bond), drainage components, a fascia extender and radius and custom fabrication. Welded corners and scuppers are available for aluminum only. The 12 ft length gives 20 to 40 percent saving in material handling compared with 8 ft or 10 ft lengths.

A wide variety of colors and finishes is available. PAC-CLAD colors are Kynar-based 70% PVDF coatings. Mill finish and clear and colored anodized aluminum are also offered. The edge system works with the membranes in flat roofing systems.