Flush and Reveal Wall Panels

Flush and Reveal Wall Panels are flat-faced PAC-CLAD wall cladding panels from Petersen. They are used on walls, fascias and soffits, and they are made with either a flush joint or a reveal joint. The two joint types are the Flush and Reveal configurations.

On-center dimensions are designed to complement Petersen's roofing panel line.

Panel lengths run from 4 feet to 25 feet. Panels are factory formed to length to reduce field cutting. A 12 inch panel is listed, and it has a reduced fastener flange.

Pencil ribs are optional, in one or two ribs per panel. Optional pencil ribs are recommended for longer panel lengths. Panels are leveled to remove coil set, crowning and edge wave at no extra charge.

The panels are fastened with a concealed system built around a rounded interlock leg. Installation is over a solid substrate with an appropriate ice and water shield, or in limited cases over framing. Panels used as windscreens are fastened through the side joints.

An optional patented concealed clip raises wind resistance. It is designed and tested for the 12 inch panel only, carries a Florida Product Approval, and is not intended to reduce oil canning. The clip can be installed on any substrate material at a spacing set by the project load table. It is made from 24 gauge stainless steel.

Flashing and trim are fabricated by the manufacturer or a qualified fabricator in PAC-CLAD aluminum from .032 to .063 gauge as specified, or PAC-CLAD steel in 24 or 22 gauge as specified. A 35-year non-prorated finish warranty is available. Vinyl masking is used for fabrication where extra handling is expected.

Panels are formed on precision roll-forming equipment with levelers, which removes coil set, crowning and edge wave. The concealed fastening system with a rounded interlock leg gives a flush appearance and adds strength. Minimum panel length is 4 feet, and the maximum is 25 feet.

The product is offered as Flush Wall Panels and Reveal Wall Panels, each in flush or reveal joint configurations. A related soffit product, Flush and Reveal Soffit, is listed in the PAC-CLAD range.